Makers, developers and hobbyists that are looking for an easy way to connect Arduino wireless sensors to an Arduino development board, might be interested in a new system that has been created by ...

According to [Dr. Tom Lehrer’s] song Pollution, “Wear a gas mask and a veil. Then you can breathe, long as you don’t inhale!” While the air quality in most of the world hasn’t gotten that bad, there ...

BMV080 is a low-power, low-cost PM1, PM2.5, and PM10 sensor module with I2C and SPI interfaces that sells for just $29.90.

The hardware setup shown below includes the Arduino Uno R4, a DHT11 sensor, and the built-in Wi-Fi for email alerts. The DHT11 is connected with VCC to 5V, GND to ground, and the data pin to Digital ...

Developers, makers, and hobbyists searching for an Arduino-powered pneumatic kit may be interested in the Programmable-Air, an Arduino Nano-based pneumatics kit which will soon be launching via the ...